First of all you are just doing test runs. A test run does not archive anything. Hence a test run on SD data will not have any affect on a test run for basic data.
you have to test it individually, first the SD test run, if everything works well then you have to perform a production run, and then you do a test run for FI and continue with production run for FI, and finally general data.
the spool result from your FI test run does not show any message, this means based on your data from the selection screen that you have no data at all for this customer in table KNB1.
Since you did not show a log for SD data I can't comment on that. Check with SE16 if you have any data in KNVV for the customer.